¡@

Home 

c++ Programming Glossary: normalization

What's “wrong” with C++ wchar_t and wstrings? What are some alternatives to wide characters?

http://stackoverflow.com/questions/11107608/whats-wrong-with-c-wchar-t-and-wstrings-what-are-some-alternatives-to-wide

width encodings. Even if one strictly maintains a composed normalization some characters still require multiple code points. See http..

Converting an FFT to a spectogram

http://stackoverflow.com/questions/1679974/converting-an-fft-to-a-spectogram

is usually the largest and so a good candidate for use in normalization if that is your aim. I don't know if that is also true for audio..

How well is unicode supported in C++11?

http://stackoverflow.com/questions/17103925/how-well-is-unicode-supported-in-c11

of Unicode functionality that is nowhere to be seen like normalization or text segmentation algorithms. U 1F4A9 . Is there any way..

3D Screenspace Raycasting/Picking DirectX9

http://stackoverflow.com/questions/19150215/3d-screenspace-raycasting-picking-directx9

C++ range/xrange equivalent in STL or boost?

http://stackoverflow.com/questions/1977339/c-range-xrange-equivalent-in-stl-or-boost

4 nested loops with different ranges increments to compute normalization indexes etc. those are not necessarily performance loops and..

Portability of binary serialization of double/float type in C++

http://stackoverflow.com/questions/4733147/portability-of-binary-serialization-of-double-float-type-in-c

get this special case out of the way check sign and begin normalization if f 0 sign 1 fnorm f else sign 0 fnorm f get the normalized..

WChars, Encodings, Standards and Portability

http://stackoverflow.com/questions/6300804/wchars-encodings-standards-and-portability

interface to UTF using iconv Note that issues like Unicode normalization or diacritic replacement are outside the scope only after you..

how to achieve 4 FLOPs per cycle

http://stackoverflow.com/questions/8389648/how-to-achieve-4-flops-per-cycle

5 cycles so it's just enough to avoid latency stalls. The normalization step is needed to keep the data from over underflowing. This.. than this if you just use all zeros and get rid of the normalization step. However since I wrote the benchmark to measure power consumption..